How to install a flash drive on windows xp

ISOs are available from a number of sources, but most people will acquire them after purchasing the OS online through Microsoft, or through some other related Microsoft service. Only the ISOs directly supplied by Microsoft would have static hashes.

How the image was captured as well will have an effect on how the final boot drive turns out, so stick to official sources where possible.

Other tools exist that accomplish the same thing, but these are the only ones we can personally recommend. However, we prefer Rufus because we find it loads a lot quicker, and feels a bit faster, too.

For a great many reasons, this is still our preferred method of creating USB boot drives. To load the Windows. NOTE: As the program will state, doing this will erase all data off of the flash drive — so backup first.

If you have any issues, be sure to check out our Common Problems section below. NOTE: This method will delete the entire flash drive, so be sure to back up personal data first. Once selected, it needs to be wiped clean, have a partition created, and then be formatted. The entire command process is summed-up in this block:. At this point, the Windows setup DVD can be inserted into the drive, or the ISO mounted, and its files copied over to the root folder of the flash drive.

While the company no longer promotes the tool, it supports at least 7 and 8 just fine, so some might prefer to use it over the other solutions. Once downloaded and opened, an ISO must be chosen. If you plan to install Windows 10 on a new system, use it to recover an existing system, or upgrade a previous install of Windows 7 or 8, creating a bootable flash drive is the first step. The whole process for creating a Windows 10 bootable USB drive can be done by using the Media Creation Tool ; most systems these days will use the bit version, so grab that.

The gallery below outlines each step of the process for the basic method. There are a few things you might need to check first. Depending on where you plan to install Windows 10, you need to check which version you require, Home or Pro.

You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Thread starter Eric Legge Start date Feb 17, Status Not open for further replies. The following free tutorial tells you how to do it. This tutorial is some kind of manual which you have to follow, in order to let your modified Windows XP run on your USB device.

Therefor you have to regard some requirerments which are also important to the avoidance of any infringment of the copyright of microsoft. Wait for a few seconds for the process to complete and you will see a prompt to allow the utility to format the USB fash drive. This process will take a few minutes and depends on the speed of the flash drive.

After the files are copied, you will see a popup window asking you for permission to copy files from the temp drive to the USB flash drive. Finally, after all the processes are complete, you will see yet another popup window asking if you want to unmount the virtual drive. Exit the Command Prompt now and you will see that your flash drive is ready to install Windows XP to another computer.

To install Windows XP to the computer, you will have to do the following steps.. Follow the necessary steps to install Windows XP and your computer will be up, raring and ready to go and running Windows in no time.

This is an easy and better way to install your Operating System as a USB port is available on every system. Great post. I was checking constantly this blog and I am impressed!

I was seeking this certain info for a very long time. Thank you and good luck. Run the software, then select your USB drive from the list of devices.

Select to format to the FAT file system, then click 'Start' to format the drive. Press 'Enter. Click 'Tools,' then 'Folder Options.

Click 'OK. Copy 'boot. Paste these files into your USB drive. Download, install and run PEBuilder to your computer.